← Back to exam page

300-620 – Implementing Cisco Application Centric Infrastructure (DCACI)

Loading demo links...

Showing 7–9 of 15 questions

Question 7 (ACI Anywhere)

What are two requirements for the IPN network when implementing a Multi-Pod ACI fabric? (Choose two.)

Select all that apply, then click Submit answer.

  • ○

    EIGRP routing
  • ○

    PIM ASM multicast routing
  • ○

    BGP routing
  • ○

    VLAN ID 4
  • ○

    OSPF routing
Question 8 (New Update)

An engineer must advertise a bridge domain subnet out of the ACI fabric to an OSPF neighbor. Which two configuration steps are required? (Choose two.)

Select all that apply, then click Submit answer.

  • ○

    Configure Subnet scope to Advertised Externally
  • ○

    Add External Subnet for External EPG flag under External EPG.
  • ○

    Create Route Control Profile with the export direction under External EPG.
  • ○

    Add L30ut profile to the bridge domain using Associated L30uts section
  • ○

    Configure the Subnet under the EPG level.
Question 9 (New Update)

A bridge domain for a new endpoint group in the Cisco ACI fabric must meet these requirements:

The bridge domain must function as the default gateway for the subnet so that routing remains within the Cisco ACI fabric.

ARP requests must be managed via Layer 3 unicast packets or be dropped to reduce excessive broadcast traffic.

The impact of misconfigured virtual machines must be kept to a minimum by preventing IP addresses outside of the configured subnet from being routed.

Which set of actions must be taken?

 

Select an option, then click Submit answer.

  • ○

    Disable ARP Flooding.
    Enable Limit IP Learning to Subnet.
    Enable Unicast Routing on the bridge domain and configure a subnet.
     
  • ○

    Enable Limit IP Learning to Subnet.
    Enable Unicast Routing on the bridge domain and configure a subnet.
    Set Multi-Destination Flooding to Flood in BD.
     
  • ○

    Set Endpoint Retention Policy to default.
    Enable ARP Flooding.
    Enable Unicast Routing on the bridge domain and configure a subnet.
     
  • ○

    Enable Unicast Routing on the bridge domain and configure a subnet.
    Set L2 Unknown Unicast to Flood.
    Disable Endpoint Retention Policy.