Introduction of HP HPE7-A09 Exam!

The HPE7-A09 exam is the current exam for the HPE Aruba Networking Certified Expert - Switching (ACX-S) certification from HP. It validates the knowledge and hands-on skills described in the official HPE Aruba Networking Certified Expert - Switching (ACX-S) written exam syllabus, and it is the version of the exam that succeeds HPE6-A69. Employers use HPE Aruba Networking Certified Expert - Switching (ACX-S) as a hiring signal for expert-level roles, because it shows a candidate can do the work the certification describes, not just describe the theory.

What is the Competency Level required for HP HPE7-A09 Exam?

HPE7-A09 is a expert-level exam. It assumes you are ready to apply the skills of Aruba Networking Certified Expert - Switching (ACX-S) written exam in real working situations — the questions describe scenarios you would meet on the job and ask what you would do, rather than asking for definitions alone.

What is the Question Format of HP HPE7-A09 Exam?

The HPE7-A09 exam uses multiple-choice questions covering design, implementation and troubleshooting of the technology.

How Can You Take HP HPE7-A09 Exam?

You book and sit the exam through Pearson VUE at a test center. Either way you schedule at a time that suits you, pay with a voucher or card, and receive your score report as soon as you finish.

What Language HP HPE7-A09 Exam is Offered?

English is the primary language of the HPE7-A09 exam. HP publishes the current language list on the exam's booking page — availability varies by region and can change as the exam rolls out worldwide.

What is the Target Audience of HP HPE7-A09 Exam?

HPE7-A09 is written for people whose work covers HPE Aruba Networking Certified Expert - Switching (ACX-S): practitioners formalizing experience they already have, and candidates moving into expert-level roles who need a recognized credential behind their skills.

Who are the Testing Providers of HP HPE7-A09 Exam?

HP sets the exam content and sells the voucher; delivery is handled by Pearson VUE, which runs the booking, identity checks and the testing environment on the day.

What is the Recommended Experience for HP HPE7-A09 Exam?

HP writes HPE7-A09 for people with hands-on experience in Aruba Networking Certified Expert - Switching (ACX-S) written exam — the exam rewards time spent doing the work over time spent only reading about it.

What are the Prerequisites of HP HPE7-A09 Exam?

HPE publishes any prerequisite certifications or training for the certification in its datasheet; where a prerequisite exam exists it must be held before the credential is awarded.

What is the Expected Retirement Date of HP HPE7-A09 Exam?

No retirement date has been announced for the HPE7-A09 exam — it is the current version, and its predecessor HPE6-A69 is the version that has been retired. The certification's validity term is set by HPE in the certification datasheet.

What is the Difficulty Level of HP HPE7-A09 Exam?

Most candidates rate HPE7-A09 as moderately difficult for its level. The questions reward solid fundamentals plus practical judgment: well-practised candidates usually find the exam fair, while candidates who only memorize terms usually do not. Time management matters — practise under timed conditions before the day.

What is the Roadmap / Track of HP HPE7-A09 Exam?

HPE7-A09 sits inside the HPE Aruba Networking Certified Expert - Switching (ACX-S) track in HP's certification program. It is the current credential at its level in that family, and holders typically build on it with the higher-tier certifications in the same family or with complementary certifications in adjacent technology areas.

What are the Topics HP HPE7-A09 Exam Covers?

The HPE7-A09 syllabus is published in HP's official exam guide and covers Aruba Networking Certified Expert - Switching (ACX-S) written exam end to end — the same body of work the certification describes. The Study4Pass practice material for HPE7-A09 follows that published scope.

What are the Sample Questions of HP HPE7-A09 Exam?

The fastest way to sample HPE7-A09 questions is the free practice test on this page — real exam-style questions with full explanations, no signup needed. The set on this page currently holds 50 questions; the first 10 are free in the web test engine. HP also publishes the official exam objectives, which are worth reading alongside any question set because they list every topic the exam can draw from.

← Back to exam page

Free HPE7-A09 – HPE Aruba Networking Certified Expert - Switching (ACX-S) Practice Test Question

Free demo downloads

Loading demo links...

Showing 1–10 of 10 questions

Question 1

Refer to the exhibit.

Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev

The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and 10.102.26.0/24 Which statement is true regarding the routing troubleshooting?

Select an option, then click Submit answer.

○
Multi-protocol BGP routing needs to be defined for route leaking
○
Route Distinguisher needs to be set to 1 for default VRF.
○
Route leaking is supported between non-default VRFs only
○
Route leaking between default and non-default VRFs is supported with Aruba CX 8400.

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 2

You have created an OSPF neighbor configuration with ArubaOS-CX 8320 VSX and a third-party switch The OSPF peering falls. In the event togs you see the following entries.

Which statement is true about the above events?

Select an option, then click Submit answer.

○
The ArubaOS-CX switch requires plain-text authentication with OSPF.
○
The third-party switch should be configured with MD5 authentication
○
The ArubaOS-CX switch does not expect authentication with OSPF.
○
The third-party switch should be configured with key chain authentication

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 3

When applying me following access-Iist to an ArubaOS-CX 6300 switch:

How does this ACL behave on the selected switch? (Select two.)

Select all that apply, then click Submit answer.

○
The mp traffic to MANAGEMENT-SERVERS group is logged to me event logs
○
The tftp traffic to MANAGEMENT-SERVERS group is not logged to the event logs.
○
The snmp-trap traffic to MANAGEMENT-SERVERS is logged to the event togs.
○
The denied tcp traffic to the MANAGEMENT-SERVERS group is logged to event logs.
○
The denied tcp traffic to the MANAGEMENT-SERVERS group is not logged to event logs

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 4

The customer is considering Implemented the following VSX configuration that will host an Aruba mobility cluster servicing 9000 dual stack employee devices.

The client's default gateways will be hosted on the VSX stack. The customer is seeking advice about how to ensure ArubaOS-CX VSX best practices have been applied.

$C:\Users\wk\Desktop\mudassar\Untitled.jpg$

What advice can you offer the customer? (Select two)

Select all that apply, then click Submit answer.

○
The ISL Bandwidth should be upgraded
○
Agg-1 and Agg-2's hardware forwarding table profile should be changed to "L3-agg''.
○
The -system-mac' of Agg-1 should be changed to an unused address from the unicast private address range
○
The vsx linkup-delay timer is unnecessarily high; it should be reduced to prevent excessive delay of packet forwarding when a VSX peer joins an existing master.
○
The Keepalive interface should be changed to interface LAG2 so there is redundancy through the mobility cluster.
○
The keepalive subnet is misconfigured, it has an inappropriate address on Agg-1.

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 5

(Scenarios may contain multiple errors which may or may not Impact the solution > Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration it is required to implement VSX keep-alive at the aggregation layer.

The ports of the ArubaOS-CS 8325 switches used for Agg01 and Agg02 are populated as follows:

The configuration of switch AGG01 includes:

$C:\Users\wk\Desktop\mudassar\Untitled.jpg$

VSX keep-alive is not working. Which modification should you make lo resolve the error condition?

Select an option, then click Submit answer.

○
Edit interface 1/1/48, adding the command "vpn-instance KA"
○
Modify the Interface lag 2 command, removing "multi-chassis"
○
Modify the Keepalive peer 192.168.20.2 source 192 168.20.1 command, adding "vrf KA"
○
Edit the vsx-sync command, adding "keep-alive"

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 6

(Scenarios may contain multiple errors which may or may not impact the solution )

Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration It is required to implement VSX at the aggregation layer

The pons of the ArubaOS-CX 8325 switches used for Agg01 and Agg02 are populated as follows:

The configuration of switch AGG01 includes

$C:\Users\wk\Desktop\mudassar\Untitled.jpg$

The VSX cluster is not forming. Which modification should you make to resolve the error condition?

Select an option, then click Submit answer.

○
Modify the system interface-group 4 speed tOg command change "25g" to "10g"
○
Modify the keepalive peer 192.168 20.2 source 192 168.20 1 command, changing "vrf KA" to "vrf mgmt"
○
Edit the vsx-sync command, adding "keep-alive"
○
Modify the vsx definition, changing "inter-switch-link lag 2" to" inter-switch-link lag 256"

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 7

(Scenarios may contain multiple errors which may or may not impact the solution)

Refer to the Exhibit.

An engineer has attempted to configure two pairs of switches m the referenced configuration it Is required to implement

Multi-Chassis Link Aggregation for each pair of switches

The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows

The configuration includes:

$C:\Users\wk\Desktop\mudassar\Untitled.jpg$

There is an error message stating "mismatched group speed" What should you add to the configuration to correct the error?

Select an option, then click Submit answer.

○
"system Interface-group 1 speed I0g"
○
"allow-unsupported-transceiver
○
"speed 10-full" under interfaces 1/1/12 and 1/1/13
○
"speed 40-full" under interfaces 1/1/49 and 1/1/50

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 8

An administrator is utilizing the orchestration capabilities of NetEdit. What are the two plan types that can be created'' (Select two.)

Configuration management plan

Select all that apply, then click Submit answer.

○
Firmware plan
○
Firmware plan
○
Deployment plan
○
Configuration plan

Ask AI for More Explanation

— your own AI account, opens inside the app

Question 9

An administrator has identified a denial of service attack that is stressing the management processor on the switch. Which actions can be applied to CoPP to mitigate the issue? (Select two.)

Select all that apply, then click Submit answer.

○
Set the processing priority
○
Create a policy that matches the payload of GRE traffic.
○
Regulate traffic from the OOBM Ethernet port
○
Apply multiple active polices for the classes of traffic

Ask AI for More Explanation

— your own AI account, opens inside the app

About the HPE7-A09 Free Practice Test

This page gives you a working sample of the Study4Pass practice set for HPE Aruba Networking Certified Expert - Switching (ACX-S) (HPE7-A09). Ten questions are free below, each with the correct answer marked and a full explanation. The complete set currently holds 50 questions: 34 single choices, 14 multiple choices, 2 drag drops.

The set is a starter bank for HPE7-A09: its questions are carried over from the HPE6-A69 practice set, the exam HPE7-A09 succeeds, mapped to the same subject areas — so you can start drilling now while the full HPE7-A09 bank is built out.

How to use this HPE7-A09 free practice test

Answer each question before you look anything up — guessing honestly is what makes the result useful. Then open the answer: the correct option is marked and a full explanation walks through the reasoning. If a concept still does not click, use the Ask AI panel on the question — Study4Pass is the 1st AI-Enabled exam practice website, and AI here is for understanding the concept, not a replacement for core preparation.

Work in the mode that fits your stage: Easy Practice and Hard Practice for learning, Topic Training to drill one area, Flagged Practice to revisit questions you marked, and Exam Simulation when you want the real timing pressure.

What the HPE7-A09 practice set covers

The questions follow the published scope of the HPE7-A09 syllabus: Aruba Networking Certified Expert - Switching (ACX-S) written exam. Work through them by topic, read every explanation, and use Ask AI on the concepts that do not click.

HPE7-A09 practice test — quick questions

Is this HPE7-A09 practice test really free?

Yes. The 10 questions on this page cost nothing, need no account, and include the answer and explanation for every question.

How many questions are in the complete HPE7-A09 set?

The set currently holds 50 questions. It is a starter bank carried over from the HPE6-A69 set while the full HPE7-A09 bank is built out.

Are these the real HPE7-A09 exam questions?

No — they are practice questions in the style and scope of the real exam, drawn from the HPE6-A69 practice set for the exam HPE7-A09 succeeds. Use them to measure readiness, not as a substitute for the official syllabus.