← Back to exam page

H12-261_V3.0 – HCIE-Routing & Switching (Written) V3.0

Loading demo links...

Showing 13–15 of 20 questions

Question 13

About filter-Policy is the following description correct? (single choice )

Select an option, then click Submit answer.

  • ○

    Use filter-Policy, in OSPOn ASBR in F, type5 can be LSA and type7 LSAgeneration is filtered.
  • ○

    Prefix lists can be used to filter routes as well as to filter packets.
  • ○

    filter-policy can filter received or advertised link state information, and can modify the attributes of routing entries.
  • ○

    When using the prefix list to filter routes, the entry ip ip-prefix 1 deny 0.0.0.0 0 less-equal 32 indicates that only the default route is matched.
Question 14

Between two directly connected devices that have established IBBP neighbors, run the shutdown command to shut down the interface of one of the devices, and the BGP connection will not be disconnected immediately.

Select an option, then click Submit answer.

  • ○

    True
  • ○

    false
Question 15

The router connects two EBGP neighbors through two parallel serial cables, what method would you use to achieve this through the two parallel serial cablesBidirectional load sharing between two connected EBGP neighbors?

Select an option, then click Submit answer.

  • ○

    To configure the EBGP neighbor relationship with the loopback interface as the update source, the IGP in each AS needs to introduce two equal-cost paths to the EBGP neighbor loopback interface address; and the command "ebgp-max-
    hop" and "next-hop-local*
  • ○

    Use the command "ebgp on both ends"-load-balance"
  • ○

    Without any method, BGP will automatically realize the load balancing of traffic among different autonomous systems on the available links
  • ○

    To configure the EBGP neighbor relationship with the loopback interface as the update source, the IGP in each AS must have two equal-cost paths to the EBGP neighbor loopback interface address; and the command "next-hop-local"
  • ○

    Using the Loopback interface Establish EBGP neighbor relationship and configure EBGP Multi-hop, configure the loopback interface as the update source, and then use IGP to achieve equal-cost path load sharing between loopback addresses