← Back to exam page

Free 300-510 – Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) Practice Test Question

Free demo downloads

Loading demo links...

Showing 4–6 of 15 questions

Question 4 (Unicast Routing)

What are two differences between OSPF and IS-IS? (Choose two.)

Select all that apply, then click Submit answer.

  • ○

    Unlike IS-IS routers, an OSPF router belongs to only one area in addition to the backbone area
  • ○

    OSPF uses a router ID to identify a router, and IS-IS uses a system ID
  • ○

    OSPF is a link-state routing protocol, and IS-IS is a distance-vector routing protocol
  • ○

    Unlike OSPF, IS-IS supports virtual links
  • ○

    OSPF elects a DR and BDR, and IS-IS elects a DIS
Question 5 (New Update)

While configuring Cisco NSF awareness, a network engineer enters the bgp graceful-restart command after the BGP session is established in a router that runs IOS XE Software. Graceful restart capabilities are not exchanged. Which two actions should be taken? (Choose two.)

Select all that apply, then click Submit answer.

  • ○

    Reload the router
  • ○

    Verity that BGP route dampening is configured
  • ○

    Reduce BGP convergence time
  • ○

    Issue the clear ip bgp * command
  • ○

    Issue the show ip bgp neighbors command.
Question 6 (Unicast Routing)

What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)

Select all that apply, then click Submit answer.

  • ○

    A dynamic IPv6 address must be configured
  • ○

    A dynamic IPv4 address must be configured
  • ○

    A static IPv4 address must be configured
  • ○

    A static IPv6 address must be configured
  • ○

    Each tunnel endpoint must support IPv4 and IPv6
  • ○

    Cisco Express Forwarding must be enabled