Loading demo links...
Showing 1–15 of 15 questions
DRAG DROP
Drag and drop the actions from the left onto the faults that they resolve on the right. Not all actions are used.
Select and Place:
Answer is in the explanation below.
An engineer must place a Cisco UCS B-Series Server in a single server pool in Cisco UCS Manager. The engineer creates a qualification policy, but the server is still seen in multiple pools. Which two actions resolve the issue? (Choose two.)
Select all that apply, then click Submit answer.
Select the Server Pool Policy from the qualification drop-down menu in the Server Pool Policy Qualification.
Set the number of vNICs qualifier inside the Server Pool Policy.
Set the operating system qualifier inside the Server Pool Policy Qualification.
Set the storage capacity qualifier inside the Server Pool Policy Qualification.
Select the Server Pool Policy Qualification from the qualification drop-down menu in the Server Pool Policy.
Refer to the exhibit. The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)
Select all that apply, then click Submit answer.
Match the vPC domain ID between the two devices.
Configure the IP address on the interface.
Activate VLANs on the vPC.
Correct the configuration of the vPC peer link and the vPC peer keepalive.
Configure one of the switches as primary for the vPC.
Refer to the exhibit. To avoid service disruption, an engineer must move the_ server from LEAF_ 1 to LEAF_ _2. After running the test, the engineer noticed that L EAF_ 2 failed to forward network traffic into the VXL AN fabric. The BGP, interface NVE, and VNI were confirmed to be configured as expected. Which two actions must be taken on L EAF_ 2 to resolve the issue? (Choose two.)
Select all that apply, then click Submit answer.
Change the fabric forwarding anycast-gateway-mac MAC address.
Add fabric forwarding mode anycast-gateway on interface Vlan100.
Configure correspondent IP addressing on every interface.
Remove ip forward from interface VIan30 and add it on interface Vlan100.
Enable HMM tracking to advertise host routes into the VXL AN fabric.
A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)
Select all that apply, then click Submit answer.
Configure the NVE interfaces to be Up on both switches.
Set a different distributed gateway virtual MAC address.
Set a different secondary IP addresses on NVE source-interface.
Configure the same VNI to multicast group maping.
Set a different primary IP addresses on NVE source-interface.
Refer to the exhibit. After a failover occurs, which two actions must be performed on Switch-B to manually preempt the operational primary role back to Switch-A? (Choose two.)
Select all that apply, then click Submit answer.
Configure the local vPC role priority to have a lower value than Switch-A.
Configure the local vPC role priority to have a higher value than Switch-A.
Disable and then re-enable the vPC peer-keepalive link.
Configure the local vPC role priority to have the same value as Switch-A.
Disable and then re-enable the vPC peer link.
An engineer implements a storage VDC, but it fails. Which two prerequisites must be in place before a storage VDC is implemented? (Choose two.)
Select all that apply, then click Submit answer.
M Series module
ESSENTIALS license
STORAGE-ENT license
FCoE license
F Series module
An engineer attempts to register Cisco UCS Manager to Cisco UCS Central, but the registration fails. The engineer can ping Cisco UCS Central from UCS Manager. Which two actions must the engineer attempt to resolve the problem? (Choose two.)
Select all that apply, then click Submit answer.
Synchronize the date and time to NTP for Cisco UCS Central and the Cisco UCS domains.
Apply the UCS Central license to UCS Central.
Place Cisco UCS Manager on the same subnet as Cisco UCS Central.
Allow port 443 between Cisco UCS Manager and Cisco UCS Central.
Allow port 9443 between Cisco UCS Manager and Cisco UCS Central.
Refer to the exhibit.
After an unexpected reload of the Cisco Nexus 9000 Series Switch, the network administrator noticed that one of the Software Maintenance Upgrades (SMU) images is inactive. The engineer must ensure that the package remains active after the switch is reloaded in the future. Which action accomplishes this goal?
Select an option, then click Submit answer.
Commit the package using the install commit command.
Save the running configuration after activating the package.
Deactivate and uninstall the active core package.
Copy the SMU package file on the bootflash.
Refer to the exhibit. The expected routes are not being leaked as expected from VRF RED to VRF BLUE. Which action resolves the issue?
Select an option, then click Submit answer.
Include the "le 32" knob under the RED_TO_BLUE_ACL prefix list.
Change the route targets under the VRFs.
Configure VRF BLUE under the BGP configuration.
Set the community to 65000:65000 under the route map.
Refer to the exhibit. One of the vPC VTEPs fails to route VXLAN traffic to vPC connected hosts. When the issue was being diagnosed, it was discovered that the packets that were expected to be forwarded to the MAC address on the SWITCH-VTEP-1 are instead forwarded to the MAC address on SWITCH-VTEP-2 and then dropped. Which action resolves the issue?
Select an option, then click Submit answer.
Configure a distributed anycast gateway on both peers
Configure ip arp synchronize under the VPC domain on both peers
Configure peer-gateway under the VPC domain on both peers
Configure a different secondary IP address for one of the vPC peers
Refer to the exhibit.
A network engineer notices packet drops on FCoE traffic from the servers. Which action resolves the issue?
Select an option, then click Submit answer.
Apply flowcontrol receive on the interface.
Apply flowcontrol transmit on the interface.
Enable priority flow control on the interface.
Disable priority flow control on the interface.
Refer to the exhibit.
A network engineer upgrades the firmware of a Cisco Fabric Interconnect from boot flash. During the process, the fabric interconnect reboots and displays the message shown in the exhibit. Which action resolves the issue?
Select an option, then click Submit answer.
Remove the service pack and upgrade through the auto-install procedure
Reset the I/O module and install the firmware image from the boot flash
Boot the kickstart image from boot flash and load the system image
Reload the switch and boot the kickstart image from the TFTP server
An engineer experiences an issue presented with the Cisco ucs system. Which action resolves the issue?
Select an option, then click Submit answer.
Change the discovery policy backplane speed preference to 4x10G.
Connect the adapter to the fabric interconnects using a breakout cable.
Update the 1/O module firmware on the Cisco UCS chassis.
Reboot the blade server and acknowledge the fault.
Refer to the exhibit. Partial configuration from N9K-1 and N9K-2 is included. The client has two WANs connected.
WAN-1 is for normal business-day activities.
WAN-2 is for server backups during nonworking hours of 1:00 a.m. to 5:00 a.m. daily.
The client says that at the scheduled time for backup, the data center server failed to use the WAN-2 link to back up the servers to the cloud backup system. What is the solution to this problem?
Select an option, then click Submit answer.
The event timer must be written in epoch time format.
The Cisco Nexus switch must be configured with one applet because a configuration with two applets will fail.
The Cron entry must be configured without double quotes.
The applet called “Backup” must include an action to remove the current static route.
Prepare for the Troubleshooting Cisco Data Center Infrastructure (300-615 DCIT) (300-615) exam with this free practice test from Study4Pass, built around the real Cisco syllabus. The 15 questions come free from the full 217-question Study4Pass practice set — a quick, honest check of where you stand. The free sample includes 7 single-answer, 7 multiple-answer and 1 drag-and-drop questions — the same mix of formats you will meet in the full set. The set follows the real exam’s spread of topics: Network, Compute Platforms, Management and Operations and Automation. The Cisco 300-615 exam is a 90-minute exam associated with the CCNP Data Center certification.
The target audience for the Cisco 300-615 exam are network engineers who have an understanding of data center solutions and technologies. The prerequisite for Cisco 300-615 exam is having a valid CCNP Data Center Certification.
Work through the questions one at a time and read every explanation, even for the ones you get right — the reasoning behind an answer is what the real exam tests. If one area keeps costing you marks, you have found exactly what to revise before exam day.
Think of the result as a map, not a verdict. The questions you miss point straight at the topics that need work, and the explanations tell you why the correct option wins. Candidates who loop through that cycle — practise, review the reasoning, re-test — walk into the real exam having already seen their weak spots and fixed them.
Inside the full 300-615 practice set:
There is no clock and no account needed. Answer each question, check the result, and read the explanation before moving on. For anything that still feels unclear, Ask AI is built into this AI-Enabled practice test — it explains the concept behind the question so the next one like it gets easier. When the free sample feels comfortable, the full set of 217 questions adds timed Exam Simulation, topic-by-topic training, and flagged-question review — the closest thing to exam day you can get before the real thing.
Yes. Every question on this page — all 15 of them — is free to use, and you never need to create an account to try them.
The full Study4Pass set for 300-615 has 217 practice questions. This page gives you 15 of them free so you can judge the quality and difficulty first.
Yes. Check any question to reveal the correct answer and its explanation, and use Ask AI whenever you want the underlying concept explained step by step.
No — these are practice questions built to match the 300-615 domains and difficulty level, so you can prepare for the real exam with confidence.
