← Back to exam page

H13-629 – HCIE-Storage (Written) (Internetwork Expert-Storage)

Loading demo links...

Showing 10–12 of 15 questions

Question 10

In the OceanStor VIS6600T dual-redundant switch network environment, using OceanStor Toolkit inspection found that "multi-path state detection "does not pass the inspection report. It is found that there are two routes in the 4 paths of the

VIS6600T device's 0 node to each LUN of the array. The path status is disabled. According to the analysis, the switch port connected to port 0 of port A0 of node 0 on node 0 of the VIS6600T is visible on the optical switch. The received optical power is much lower than the rated power of the optical module. What actions should be taken to fix this?

Select an option, then click Submit answer.

  • ○

    Replacing the optical module of port 0 in slot A0 of node 0.
  • ○

    Replacing the light of the P0 port in the A0 slot of 0 node.
  • ○

    Replacing the optical module of the port connected to port 0 of the corresponding 0-node A0 slot on the switch.
  • ○

    Reseat the FC interface card corresponding to slot 0 of node A0.
Question 11

In dual active disaster recovery solution architectures, the two FC switches will use the same domain ID after cascading to divide the zone.

Select an option, then click Submit answer.

  • ○

    True
  • ○

    False
Question 12

Which of the following is incorrect regarding the Sompana oracle backup configuration?

Select an option, then click Submit answer.

  • ○

    In the backup parameter settings "max open files" parameter defines the maximum number of files to be read in parallel per channel, which is the RMAN MAXOPENFILES parameter
  • ○

    "Command line backup" and "Log Backup" select the storage strategy for the database and archive logs, both need to choose the same storage strategy
  • ○

    The "data files per BFS" parameter in the backup parameter settings specifies the number of data files that can be simultaneously written to the same Back Set number
  • ○

    To achieve Oracle RAC table-level recovery, the backup parameter settings must be in the "option" tab check the "enable table browse "option