← Back to exam page

HPE6-A41 – Applying Aruba Switching Fundamentals for Mobility

Loading demo links...

Showing 1–3 of 10 questions

Question 1

Refer to the exhibit.

A network administrator installs a new aggregation and access layer in a campus network. All users in this area belong to the same VLAN. The administrator plugs the switches into the network with the factory default configurations.

Which protocol must the administrator configure to prevent broadcast storms?

Select an option, then click Submit answer.

  • ○

    MSTP
  • ○

    LLDP
  • ○

    OSPF
  • ○

    LACP
Question 2

Refer to the exhibit.

A network administrator connects several new Aruba Instant APs (at factory defaults), as shown in the exhibit. After waiting several minutes for the cluster to form, the administrator is ready to provision the cluster. The administrator wants to be redirected to the Instant UI without the need to know the correct IP address.

How should the administrator connect the management station to enable access to the virtual controller (VC)?

Select an option, then click Submit answer.

  • ○

    to a switch port in the same VLAN
  • ○

    directly to one instant AP’s second Ethernet port
  • ○

    to the Instant SSID
  • ○

    directly to one Instant AP’s Basic Service Set (BSS)
Question 3

Refer to the exhibit.

Which issue could cause the Blocked status on A2?

Select an option, then click Submit answer.

  • ○

    A1 and A2 are connected to different switches.
  • ○

    A1 and A2 use different trunk load balancing modes.
  • ○

    A1 and A2 support different VLANs.
  • ○

    A1 and A2 have spanning tree enabled on the link aggregation.