← Back to exam page

4A0-104 – Alcatel-Lucent Services Architecture

Loading demo links...

Showing 1–3 of 15 questions

Question 1 (Volume B)

Which of the following conditions are necessary in order for service labels to be signaled between two PE routers? (Choose three.)

Select all that apply, then click Submit answer.

  • ○

    LDP must be enabled on both PE routers.
  • ○

    RSVP must be enabled on both PE routers.
  • ○

    Traffic engineering must be enabled in the IGP.
  • ○

    The VC-ID must match between the two PE routers in both directions.
  • ○

    The transport tunnel must be operationally up between the two PE routers in both directions.
  • ○

    The SDP ID must match between the two PE routers in both directions.
Question 2 (Volume B)

Which of the following are characteristics of an IES service? (Choose two.)

Select all that apply, then click Submit answer.

  • ○

    A virtual routing/forwarding table is created per IES service.
  • ○

    Only one IES service can be created for a single customer ID.
  • ○

    More than one IP interface can be created within a single IES service.
  • ○

    All IP interfaces created within the same IES service belong to the same customer
Question 3 (Volume A)

Which of the following statements are TRUE about configuring a SDP between an IES and a VPLS? (Choose two.)

Select all that apply, then click Submit answer.

  • ○

    The SDP must be a mesh
  • ○

    The SDP must be a spoke.
  • ○

    Once the SDP is configured on both PE routers, both the services will be operationally up without further configuration changes.
  • ○

    The Layer 2 MTUs must match between the IES and the VPLS
  • ○

    The Layer 2 MTU must be 14 bytes smaller on the VPLS than it is on the IES.