NSE4_FGT-7.2 Sample Questions and Passing Score

NSE4_FGT-7.2 Sample Questions and Passing Score
Five original NSE 4 sample questions with worked answers, plus the truth on the passing score: Fortinet publishes no fixed mark, so results are pass/fail.

The passing score question, answered honestly

Start with the part most preparation sites get wrong: Fortinet does not publish a fixed passing score for the NSE 4 exam. Your result is reported as pass or fail. Any website quoting an exact percentage — sixty, seventy, whatever the number — is guessing, or repeating an old forum figure dressed up as inside knowledge. Treat those numbers as fiction: you cannot aim at a known cut line, so aim to be comfortably strong in every exam area instead.

What Fortinet does publish is the shape of the test. As currently listed, the FortiGate 7.2 exam (NSE4_FGT-7.2) contains around 70 questions with about 105 minutes to answer them — roughly ninety seconds per question. Confirm the current count and duration on the official exam page before booking, because Fortinet adjusts its exams as firmware generations move on. The five questions below follow the exam's style: a concrete FortiGate situation, one defensible answer, and distractors built from real administrator mistakes.

Five sample questions, worked properly

Sample question 1. An administrator adds a FortiGate policy allowing LAN-to-WAN HTTP and HTTPS traffic, but users still cannot browse the web — although the same traffic worked yesterday. What should you check first?

  • A. Reboot the FortiGate to clear stale sessions
  • B. Whether an earlier policy matches this traffic first and denies it — or whether the new policy's address objects actually match the users' traffic
  • C. Whether the WAN interface has run out of licensed bandwidth
  • D. Whether the FortiGate's firmware needs an immediate upgrade

Answer: B. A FortiGate evaluates firewall policies from the top of the list downward; the first matching policy decides the traffic's fate, and an implicit deny waits at the bottom if nothing matches. A deny policy above the new one, or address objects that quietly exclude the users, explains "worked yesterday, broken after a policy change" far better than anything else listed. Rebooting (A) is the strongest distractor and the worst first move: it destroys the session and log evidence you need, and if the policy table is the problem, the fault returns as soon as traffic resumes.

Sample question 2. An office has 200 internal hosts using private IPv4 addresses and a single public IP address from its ISP. Every host needs outbound Internet access. Which NAT configuration achieves this?

  • A. Destination NAT with a virtual IP object for each internal host
  • B. Source NAT in the outbound firewall policy, translating all internal sources to the outgoing interface address (or to an IP pool)
  • C. A static one-to-one NAT mapping for each of the 200 hosts
  • D. NAT64 translation on the WAN interface

Answer: B. This is source NAT with port address translation: many private sources share one public address, separated by source ports. Direction is the whole question. Destination NAT and virtual IPs (A) solve the opposite problem — publishing an internal server to the Internet. One-to-one mappings (C) are a legitimate NAT form but would require 200 public addresses the office does not have. NAT64 (D) translates between IPv6 and IPv4, which is not the situation described.

Sample question 3. A café wants guest Wi-Fi users to enter a username and password on a web page before they can browse the Internet through the FortiGate. Which feature provides this?

  • A. A guest firewall policy with the service set to ALL
  • B. Firewall authentication with a captive portal applied to the guest traffic
  • C. A web filter profile with the social networking category allowed
  • D. An SSL VPN portal configured for tunnel mode

Answer: B. Identity before access is a firewall authentication problem: the FortiGate intercepts the guest's first web request, presents a captive portal, and applies the policy once the credentials check out. Widening the policy (A) removes control instead of adding identity. A web filter profile (C) decides which categories of site are allowed — it knows nothing about who the user is, which is why it tempts. SSL VPN (D) serves remote users, not guests already on the local network.

Sample question 4. An IPsec tunnel between two FortiGates is down. Phase 1 completes successfully and both gateways use the same pre-shared key, but Phase 2 never establishes and no traffic passes. What is the most likely cause?

  • A. The pre-shared key does not match
  • B. The Phase 2 proposals (encryption and authentication algorithms, or the DH group) — or the Phase 2 traffic selectors — do not match on both sides
  • C. The two WAN interfaces belong to different ISPs
  • D. The tunnel interfaces have no IP addresses assigned

Answer: B. Work the symptom. Phase 1 is up, which proves the gateways can reach each other and agree on Phase 1 parameters — including the pre-shared key, which is exactly why A is the strongest distractor and also wrong. A failure isolated to Phase 2 points at what Phase 2 negotiates: its own proposals, and the selectors defining which traffic the tunnel protects. Different ISPs (C) are irrelevant, and unnumbered tunnel interfaces (D) are normal in route-based VPNs.

Sample question 5. An administrator must block social networking websites for staff and keep a record of access attempts for later review. What is the correct approach?

  • A. Create DNS filter entries for each social networking domain individually
  • B. Apply a web filter profile that blocks the relevant category with logging enabled, and reference that profile in the staff firewall policy
  • C. Build a deny policy listing the IP addresses of the major social networks
  • D. Use application control to block all web browsers

Answer: B. Category-based web filtering exists precisely for this requirement: the profile blocks the category, its logging setting records the attempts, and it takes effect because the profile is attached to the policy the staff traffic matches. The alternatives all fail structurally: per-domain DNS entries (A) never scale and leak through apps, IP lists (C) break behind content delivery networks with shifting shared addresses, and blocking browsers (D) kills the whole web rather than one category of it.

What these questions are really testing

Notice the pattern across all five. None asks you to recite a definition. Each hands you a symptom or a requirement and asks for the first check, the correct direction, or the feature that actually fits. That is why NSE 4 rewards time on the box: fluency with the policy table, the CLI behind it (get, show, diagnose), and the habit of tracing traffic before changing configuration.

Use your results diagnostically. The syllabus groups questions into areas — firewall policies and NAT, authentication, VPNs, security profiles, routing — and a wrong answer usually belongs to one area, not the whole exam. Missing both policy-flavoured questions above is not a reason to reread everything; it is a reason to spend an evening on policy order, matching logic, and flow diagnostics. Keep revision tied to the 7.2 feature set, too: material written for an older firmware generation teaches menus and behaviours that have since moved.

Finally, respect the clock. At roughly ninety seconds per question, scenario stems have to become a fast read: identify the symptom, name the mechanism, then judge the options. Full-length timed practice, scored by syllabus area, converts FortiGate familiarity into exam-ready pace — and timed, domain-scored free practice tests on Study4Pass are one straightforward way to rehearse exactly that. If your first attempt falls short, check the NSE 4 retake policy before rebooking, read how difficult the NSE4 exam is, and follow the NSE4 exam roadmap to structure your preparation.

NSE4_FGT-7.2 Practice & Study Material

Related Fortinet Certifications

Share this guide X Facebook LinkedIn WhatsApp

Written by

Study4Pass Editorial Team

Study4Pass Editorial Team

The Study4Pass Editorial Team publishes practical IT certification study guides, exam breakdowns and preparation strategies based on the current exam objectives.